Offering water jet cutting machine for glass:

* Principle of water jet:
- A series of high-pressure lines, pumps and intensifiers force a stream of filtered water through a tiny orifice in a jewel.

- The stream, which is pressurized up to 60,000 psi, mixes with fine abrasive garnet in a tube to provide extraordinary cutting power. Motion-controlled machines transport the jet nozzles along programmed paths to cut complex profiles.

- Water jet machine can cut range of materials: acrylic, alloys, aluminum, brass, carpet, ceramic, composites, copper, corian, felt, foam, fiberglass, formica, gaskets, glass, granite, inconel, insulation, laminates, leather, marble, plastics, quartz, rubber, silicone, stainless steel, steel, stone, titanium, wood, etc.

- Water jet machine uses cold supersonic abrasive erosion to cut almost any materials both metals and nonmetals. The highly pressurized water stream is forced through a tiny area which carries abrasive garnet to erode away the material.

- This machine can be used for following applications and industries:
ceramics, stones, glass, metal artwork, metal cutting, exotic & non traditional materials, automotive, aerospace, electronics, job & machine shop applications, etc.

* Advantages of water jet technology:
- Old cutting without thermal influences.
- Flexible processing of virtually all materials with consistent high quality.
- Material-saving production due to reduced cutting width and the nesting of several parts on a single sheet.
- Maximum degree of material utilization due to the smallest of part separation distances (partially free of burrs) and part-in-part production.
- Tension-free processed parts due to minimal cutting force.
- Environmentally friendly and clean production without poisonous gases.