Offering bee prog multiprogramming:

The Bee Prog+/BeeProg programmer is extremely fast and totally reliable universal programmer that support 41699 chips by actual 2.51 version of software (12,Oct. 2008).

The BeeProg+/Beeprog programmer is basically intended as powerfull engineering programmer, useable also as a single-site programmer in volume production.

By operating multiple BeeProg+/Beeprog programmers simultaneously you can use them in high volume production environment - other words, using more BeeProg+/Beeprog programmers you can get a universal, up to 4 programming sites multiprogrammer with 48-pin DIP ZIF sockets, connects to PC by USB port. It is important to mention, there is a concurrent multiprogramming system - each programmer works independently and each programmer can program different chip, if necessary.

The special software (PG4UWMC = PG4UW Multiprogramming control) is available for controlling of the BeeProg+/Beeprog programmers in the BeeProg+/Beeprog multiprogramming mode. There is used a project file to control the BeeProg+/Beeprog multiprogramming. Project file contains user data, chip programming setup information, chip configuration data, auto programming command sequence, etc. Therefore the operator error is minimized, because the project file is normally created and proofed by engineering and then given to the operator. The optional protected mode can be set for project file to avoid a unwanted changes of the project file.